How do i change my clutch on my 90'nissan 240sx without a tranny jack?
The trans weighs only 75 pounds two people can easily slide it off and down and back on as long as you lubricate the imput shaft splines and inside the clutch with a light coat of grease and use the alignment tool. Where the job get tricky is the pilot bushing removal I use a slide hammer with two legs the inside diameter is about 1/2 %26quot; Sand the throw out support collar smooth lubricate every contact and pivot. A new clutch will work effortlessly. always refurface the flywheel and replace the rear crank seal.
How do i change my clutch on my 90'nissan 240sx without a tranny jack?
you can by an attachment for a floor jack for about $50.00. or just bolt a piece of 12%26quot;x12%26quot;. 3/4%26quot; ply on top of a floor jack for it to sit on and wrap a strap or chain around it to stop it from falling off. It does make it harder to reinstall it. you should buy or make a couple of guide pins to make things easier on yourself. Stick shifts don't weigh that much, I've rested them on my chest or stomach to maneuever them into place by hand.
No comments:
Post a Comment