Wher do you put gear oil in after you have changed the clutch?

1994 geo metro
Wher do you put gear oil in after you have changed the clutch?
Actually, there are 2 different possibilities on the 1985-2000 Geo Metro, neither of which involve removing the speedometer gear.



With both types, it is recommended that you first bring the vehicle to operating temperature.



On models with an Oil Level Gauge, unscrew said Gauge from the top of the side case of the transaxle. Wipe clean. Fit gauge into hole without screwing in, then pull out and read gauge. Level should be between Full and Low level line. Fill as necessary. (presumably through same hole)



On models with Oil Level/Filler Plug, unscrew plug (looks like behind and slightly above drivers side halfshaft). Level should be even with the bottom of the plug hole. Fill as necessary. (again, presumably through same hole) Replace Oil Level/Filler Plug, and torque to 40 ft. lbs.



If you'd like to send me a real e-mail address, I'd be happy to scan the pictures of each and send them to you as attachments.
Wher do you put gear oil in after you have changed the clutch?
You remove the speedo gear and add fluid until its too the middle of the speedo gear.
there should be a plug on the side of the trans. better get an owners manual for amount, location and frequency of checking.
thanks scott i knew there was a way to fill those %26quot;sealed%26quot; trannys. lol